Panasonic EY7430 Bedienungsanleitung Seite 23

Troubleshooting
If during the inspection detailed below you find anything wrong with the product, please stop
using it immediately and take it back to the retailer.
Model No: EY0L32
Problem
If you attempt to charge a
battery pack after it has al-
ready finished charging, the
charging lamp will flash.
Charging causes static
which is picked up by radio
and television sets.
The battery pack has been
inserted into the charger
but the charging lamp still
does not come on.
Model No:EY7430 & EY7530
Problem
Does not turn on or it turns
on but suddenly turns off
again.
You will hear the stop
sound after switching it off.
You cannot drill many
holes, or fasten many bolts
or screws even on a full
charge.
EY7530_7430_3732_0L32_02(Eng).indd
Cause
It takes time to detect
that the battery has fully
charged.
It is controlled with high
frequency which may cause
interference.
Something is stuck be-
tween the battery pack and
the charger at the contact
points.
The battery pack gets hot.
Cause
Battery pack is not charged.
Something is stuck between
the unit and the battery pack
at the contact points.
This is the sound of the
brake functioning.
The drill or the bit is worn
down or damaged.
The battery pack was cooled
below -20°C before being
charged in a warm place.
The battery pack has
reached the end of its
service life.
- 23 -
23
Remedy
The charging lamp (green)
will be illuminated indicat-
ing it is fully charged after a
short while.
Use other outlet for charg-
ing, or charge the battery
pack somewhere away
from radio and television
sets.
Unplug the charger and
clear away whatever is
between the battery pack
and the charger.
Continue charging as usual.
It starts charging automati-
cally after cooling down.
Remedy
Please charge the battery
pack.
Remove the obstruction.
This does not mean the
product is broken.
Replace the drill or bit.
Leave it to sit for an hour,
and only charge it once it has
warmed to room temperature.
Replace the battery pack.
2014/08/18
EN
15:40:54