Maintenance; General Information; Clean The Machine; Replace The Blade - Cramer 2911486 Bedienungsanleitung

• Keep a firm grip with both hands while in operation.
• Edger should be held at a comfortable position with the
rear handle about hip height.
• The edger will edge along sidewalks, driveways, flower
beds, curbs, and similar areas.
• Cut at a steady pace. If the blade begins to bog down, you
are edging too fast; slow your pace. Do not force the
blade into ground.
• Light contact of the blade against the sidewalk edge,
curb, etc., is acceptable and will not damage the edger.
• Best appearance is obtained when grass is dry. Avoid
edging in wet soil or wet grass areas or the blade guard
might clog and result in an uneven edge. If the blade
guard becomes clogged, stop the edger, remove the
battery, and remove debris from the blade guard.
5

MAINTENANCE

IMPORTANT
Read and understand the safety regulations and the
maintenance instructions before you clean, repair or do the
maintenance work on the machine.
IMPORTANT
Make sure that all nuts, bolts and screws are tight. Check
regularly that the handles are firmly mounted.
IMPORTANT
Use only the replacement parts and accessories of the initial
manufacturer.
5.1

GENERAL INFORMATION

IMPORTANT
Only your dealer or approved service center can do the
maintenance that is not given in this manual.
Before the maintenance operations:
• Stop the machine.
• Remove the battery pack.
• Cool the motor.
• Store the machine in a cool and dry place.
• Use correct clothing, protective gloves and safety glasses.
5.2

CLEAN THE MACHINE

• Clean the machine after use with a moist cloth dipped in
neutral detergent.
• Do not use aggressive detergents or solvents to clean the
plastic parts or handles.
• Keep the trimmer head free of grass, leaves, or excessive
grease.
• Keep the air vents clean and free of debris to avoid
overheating and damage to the motor or the battery.
English
• Do not spray water onto the motor and electrical
components.
5.3

REPLACE THE BLADE

Figure 5 - 6.
If the blade worn out, replace it with a new one (not
provided).
1. Use a metal rod to fix the blade.
2. Remove the nut by turning it clockwise with the wrench
(not included).
3. Remove the outer cup and the plate.
4. Remove the old blade and replace it with a new one.
5. Place the plate and outer cup on the blade.
6. Place the nut on the plate and tighten it counterclockwise
with the wrench.
5.4

REPLACE THE SKID PLATE

Figure 7.
1. Remove the screws with a Phillips Head screwdriver (not
included).
2. Replace with the new skid plate.
3. Tighten the screws.
5.5

REPLACE THE WHEEL

Figure 8.
1. Remove the battery.
2. Remove the knob, washer, wheel, axle sleeve, washer and
wheel axle orderly from the wheel assembly.
3. Replace with the new wheel.
4. Insert the wheel axle through the slot downward, then put
the washer, axle sleeve , wheel, washer and knob orderly
through the wheel axle.
5. Tighten the knob.
6 TRANSPORTATION AND
STORAGE
Remove the battery pack from the machine before

transportation and storage.

6.1

STORE THE MACHINE

• Remove the battery pack from the machine.
• Make sure that children cannot come near the machine.
• Keep the machine away from corrosive agents such as
garden chemicals and de-icing salts.
5
NOTE
WARNING
EN