Cutting Tips; Operation Tips; Use The Shoulder Strap; Maintenance - Cramer 2101786 Bedienungsanleitung

EN
1. Remove the battery pack.
2. Remove the blade screws from the cut-off blade.
3. Turn the cut-off blade 180°.
4. Tighten the blade screws.
4.6

CUTTING TIPS

Figure 9.
• Tilt the machine towards the area to be cut. Use the tip of
the cutting line to cut grass.
• Move the machine from right to left to prevent thrown
debris toward the operator.
• Do not cut in dangerous areas.
• Do not force the trimmer head into uncut grass.
• Wire and picket fences cause cutting line wear and
breakage. Stone and brick walls, curbs, and wood can
wear the cutting line quickly.
4.7

OPERATION TIPS

Figure 10.
Keep clearance between the body and the machine.
Do not operate the machine without guard in place.
Follow these tips when you use the machine:
• Keep the machine connected to the correctly worn
harness.
• Keep a firm hold with two hands on the machine while
you operate the machine.
• Cut tall grass from the top down.
If grass winds around the trimmer head:
• Remove the battery pack.
• Remove the grass.
4.8

USE THE SHOULDER STRAP

Figure 10.
1. Attach the carabiner to the carrying ring on the pole.
2. Put on the shoulder strap.
3. Adjust the length of the strap so that the carabiner is
about the width of a hand below your right hip.
5

MAINTENANCE

Read and understand the safety regulations and the
maintenance instructions before you clean, repair or do the
maintenance work on the machine.
WARNING
WARNING
IMPORTANT
English
Make sure that all nuts, bolts and screws are tight. Check
regularly that the handles are firmly mounted.
Use only the replacement parts and accessories of the initial
manufacturer.
5.1

GENERAL INFORMATION

Only your dealer or approved service center can do the
maintenance that is not given in this manual.
Before the maintenance operations:
• Stop the machine.
• Remove the battery pack.
• Cool the motor.
• Store the machine in a cool and dry place.
• Use correct clothing, protective gloves and safety glasses.
5.2

CLEAN THE MACHINE

• Clean the machine after use with a moist cloth dipped in
neutral detergent.
• Do not use aggressive detergents or solvents to clean the
plastic parts or handles.
• Keep the trimmer head free of grass, leaves, or excessive
grease.
• Keep the air vents clean and free of debris to avoid
overheating and damage to the motor or the battery.
• Do not spray water onto the motor and electrical
components.
5.3

INSTALL THE CUTTING LINE

Figure 11 - 13.
Do not put more than 4 m of cutting line in at a time.
1. Line up the slots on the spool cap with the slots on the
trimmer head.
2. Put the cutting line through the hole. Push the cutting line
until it exits the opposite hole.
3. Pull the cutting line through until there is an equal
quantity of cutting line on each side.
4. Turn the spool cap clock-wise to wind the cutting line
into the trimmer head. Keep approximately 13 cm of
cutting line above out of each side of the trimmer head.
5.4

REPLACE THE SPOOL

Figure 14 - 17.
6
IMPORTANT
IMPORTANT
IMPORTANT
NOTE