Pool Preparation; Operation - Kokido EV75 Bedienungsanleitung

Reverse the steps to lock both latches. Make sure the hook is secured on the edge of the
cartridge filter and the latch is completely pressed down to the body.

Pool Preparation

If there are stones, roots or metal corrosion in contact with the underside of the
-
liner, discard them prior to using the pool vacuum. If necessary, seek assistance
from a qualified professional.
If the liner is brittle, damaged or wrinkled, contact a qualified professional to
-
perform the necessary repairs or perform a liner replacement prior to using the
pool vacuum.
- If you are using a saltwater pool, make sure all salt are dissolved before placing
the pool vacuum into the water.

OPERATION

WARNING!
Make sure the pool vacuum is off

Do not use the pool vacuum if any damage is detected.

Oil stain could occur due to possible leakage of lubricants applied to the

O-ring.
Do not operate this pool vacuum if there are people/pets present in the

water.
Make sure the pool vacuum is fully immersed in the pool before initiating

operation. The minimum water level required to operate the pool
vacuum must reach above the power ON/OFF switch of the pool
vacuum when it is held in a vertical position. Operating the pool vacuum
when it is not immersed correctly could damage the unit and void the
warranty.
DO NOT use the pool vacuum without an intact filter cone in place.

Using your pool vacuum without an intact filter cone in place will VOID
your warranty.
DO NOT leave the pool vacuum in the water when it is not in use.

14