Dometic COOLMATIC CRP 40 Montage- Und Bedienungsanleitung Seite 16

Setting up and connecting the refrigerator
Co-ordinate axis
l

A
NOTICE!
Make sure that the polarity is correct.
➤ Before starting up the refrigerator for the first time, check whether the operating
voltage and the battery voltage match (see data plate).
➤ For the electrical connection you also need the wiring diagram (fig. 0, page 7).
No. in fig. 0,
page 7
1
2
3
4
➤ Connect the refrigerator (fig. a, page 7)
– as directly as possible to the poles of the battery or
– to a plug socket which is fuse protected with at least 15 A (at 12 V) or 7.5 A
(at 24 V).
A
NOTICE!
Disconnect the refrigerator and other consumers from the battery
before charging the battery with a quick charging device.
Over voltages can damage the electronics of the refrigerator.
For safety reasons the refrigerator is equipped with an electronic system to prevent
the polarity being reversed. This protects the refrigerator against reversed polarity
when connecting to a battery and against short circuiting. To protect the battery, the
refrigerator switches off automatically if the voltage is insufficient (see table below).
Cut-off voltage
Cut-in voltage
16
Meaning
Cable length
Cable cross section
Meaning
Electronic terminal rail
Compressor
DC fan (if present)
Mechanical thermostat
12 V
10.4 V
11.7 V
CRP40
Unit
m
mm²
24 V
22.8 V
24.2 V
EN