Installing The Flange (Variants: Size 18 - 20) - INTORQ BFK458 Originalbetriebsanleitung

Mechanical installation
4. Check the height of the screw heads. The screw heads must not be higher than the minimum rotor
thickness. Use screws that comply with the information in the table Rated data: screw kit for brake as-
sembly on separately screwed-on flange, Page 24.
5.7.3

Installing the flange (variants: size 18 - 20)

The flange can be screwed to the end shield onto the outer hole circle (refer to the table Rated data: screw
kit for brake assembly on separately screwed-on flange, Page 24).
Fig. 16: Flange mounting for sizes 18 – 20
A
D
1)
According to the table Rated data: screw kit for brake assembly on separately screwed-on flange, Page 24
INTORQ | BA 14.0168 | 08/2019
Notice
When mounting the flange, the various size classes must be distinguished: sizes 06 – 16, 18 – 20
and 25 are mounted differently.
NOTICE
¾
Clearing holes for the screws in the end shield must be behind the threaded screw
holes in the flange. Without the clearing holes, the minimal rotor thickness cannot be
used. The screws must not press against the end shield.
¾
For sizes 18 and 20, the mounting surface threading must be angled at 30° to the cen-
ter axis to the hand-release lever.
1)
Screw
End shield
B
Flange
C
Hub
43