Denver CRQ-100 Bedienungsanleitung Seite 35

CLOCK/ALARM MODE
ALARM1 on/off, in standby mode,press button ①, ALM1
1.
time will display; press button① again, ALM 1 icon lights up
on display; press button ①the third time to turn off ALM1
function.
2. ALARM1 setting, ALM1 icon is off on display, press and
hold button ①, the hour are flashing; press buttons ③⑤ to
adjust the hours. Press button ① again, the minutes are
flashing; press buttons ③⑤ to adjust the minutes. Press
button ① again to select alarm mode. Default setting is
BUZZ, which is flashing on display; press buttons ③⑤ to
select alarm Buzzer or FM mode. Press ① button again, the
alarm volume is flashing on the display, and the unit emits
two beep tones (or FM) for alarm active. Press buttons ③⑤
to adjust the volume level, and press button① again to finish
the settings.
3. ALARM2 setting, same as Alarm1;
SNOOZE: When the alarm is working, press button ④ to
4.
pause the alarm, the zZ icon is flashing on the display. After
9 minutes the alarm is working again and the zZ icon turns
off.
CLOCK setting, in standby mode, press and hold button ⑧,
5.
the hours are flashing; press buttons ③⑤ to adjust the
hours. Press button ⑧ again, the minutes are flashing and
press buttons ③⑤ to adjust the minutes. Press button⑧
again to finish clock setting.
6. When connecting to mains power, the default mode is clock
mode and PM12:08 is displayed. Press button ⑧ to toggle
between 12/24H modes.
-4-