Setup And Operation; Device Setup - Sunoptic Surgical SSL-LX2 Gebrauchsanleitung

6. SETUP AND OPERATION

6.1. Device Setup

•
Fully charge any batteries supplied with the device.
•
Remove the rubber protective lens cap from the Headlight Module.
•
Attach the Headlight Module to the Battery Holster by connecting the latching connectors
located on the power cables. Ensure the cables are lined-up before engaging.
CAUTION: Do not force the power cables to connect as you may damage the pins. Rotate slowly
until the connectors engage.
•
Insert a fully charged battery pack into the Battery Holster, ensuring the battery pack
slots line up with the holster contacts.
•
Place headlight on your head and adjust the two ratchet knobs until the headband fit is
comfortable and snug upon the head.
•
(Optional) Attach a power cable gown clip just below the shoulder to reduce cable
weight on the headband.
•
Retaining gaskets are installed on the headlight module power cable to prevent cord
slippage from the headband. Please adjust the position of these gaskets as necessary to
reduce any unnecessary strain on the headlight. Leave enough cable slack to allow
module repositioning as shown in the figure below.
LIT-246
Sunoptic Surgical
Rev. E
Headlight Module – Battery Holster Connecting Cables
Headband Power Cord Gasket
®
Page 7 of 80
(English)