Operation; Automatic Ignition - Klarstein TRIFECTA Bedienungsanleitung

EN
38

OPERATION

Note: By using a thicker pan, it can improve heat distribution, especially when using a
small fire. The larger the size of the pot is, the higher the efficiency of the hob will be.
Whenever you want to leave the pot for a short time, please adjust flame to minimum
setting. In this way, even if you are close to the hob for other operations, it can reduce
the risk of burns, in the same time, it can save gas and reduce pollution.
When using large cookware, please ensure that the distance between the cookware
and the surrounding combustibles should be at least 25 mm, and the distance between
the knob and the cookware must be kept at least 50 mm.

Automatic ignition

• If the hob can be igniting automatically (pulse igniter): Press the control knob of the
selected burner and turn counterclockwise to the maximum fire setting. When the
control knob is held down, a spark is generated on all burners.
• The flame ignites.
• Release the control knob.
• Turn the control knob to the desired setting position.
If no flame is produced, turn the control to the "Off" setting and repeat the above steps.
This time hold down the control knob for a long time (up to 10 seconds).
Deflagration hazard
If the flame still does not ignite after 15 seconds, turn off the burner and open a nearby
window or door. After waiting at least one minute, please try turning the burner on
again.
Flame failure safety device
Some models may have a safety system (thermocouple) to prevent gas spills when the
burner is accidentally turned off.
Thermocouple
Thermocouple
Igniting needle
Igniting needle