Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Page EN-12
Assembly
Assembly
Prerequisites for installation
You have read chapter "Safety" on page EN-3.
Place the drill holes
WARNING
Risk of injury!
Improper installation of the appliance
can lead to injury.
■ Before drilling the holes, ensure that
no wires or cables (power, gas, water
etc.) will be damaged (check with a
line locator).
CAUTION
Fire hazard!
■ The distance between the cooking
surfaces and the lower edge of the
Exhaust hood must be at least 65 cm
for gas stoves.
■ For gas stovetops, you must read the
user manual for the stovetop! If the
manual stipulates a larger distance,
this must be observed.
1. In order to place the appliance exactly
over the centre of the stovetop, first use
the pencil to draw a vertical guiding line on
the wall.
Ideally, use a level or a plumb bob from
the ceiling of the room to the middle of the
stovetop.
2. To keep the prescribed distances, draw
horizontal guides according to the above
diagrams.
22.5 cm
5
24.0 cm
0
3. To maintain the lateral distances, mark the
four drill holes on the wall according to the
diagrams above.
4. Drill holes at the marked points, using a di-
ameter that can accommodate the dowels.
5. Place the dowels into the holes.
Werbung
Kapitel
Inhaltsverzeichnis
