Frost Warning - Bresser ClimaTrend WFS Bedienungsanleitung

bell symbol is not displayed the alarm is off.
8. The alarm sounds for a total of 2 minutes and will change characteristics
along that time.
SNOOZE/LIGHT FUNCTION
1. When alarm is ringing, you can press the SNOOZE/LIGHT button to si-
lence it for 5 minutes. The icon
2. Press any other button to turn off the alarm. The alarm will activate
again after 24 hours at the set time.
3. During normal operation mode, a press of the SNOOZE/LIGHT button
turns on the backlight for 10 seconds.
TEMPERATURE BUZZER SETTING
1. Press and hold the DOWN button in normal display mode for 2 seconds
to enter into temperature buzzer setting. The temperature indicator for
the remote sensor will flash and the symbol
of it.
NOTE!
Make sure that you have set the correct channel for the desired sensor.
2. Press the DOWN or UP button to set the desired value for the maximum
temperature.
will now flash as well.
will be displayed in front
3. Press the MODE button to confirm and go to the next setting.
4. The setting order is: temperature buzzer ON/OFF >> highest tempera-
ture limit >> lowest temperature limit. If the UP or DOWN button is held
and presses continuously, the value will change faster.
NOTE!
The range for maximum upper limit is 70° and maximum limit for lower
temperatures is -50°.
5. Press MODE button again to confirm and exit setting.
NOTE!
As long as the outside temperature has exceeded or fallen below the set limits,
the alarm will sound every minute for a duration of 2 seconds. Furthermore the
display for the outdoor temperature and the symbols

FROST WARNING

If the frost warning is activated, an alarm will sound for approx. 5 seconds
and the symbol will flash as long as the outdoor temperature is between
-1.0 and +2.9 °C (+30.2 and 37.3 °F).
Activate temperature alarm and/or frost warning
In normal display mode press the DOWN button to enable or disable the
GB
or are flashing.
29