Adjustable Parameters; Programming Menu - IFM Electronic Efector 160 LK8 Bedienungsanleitung

Technical information / Functioning / Parameters
Adjustable
parameters
Switch-on point: Upper limit value at which the output changes its switching status.
SP1 ... SP4 are active only if binary mode is not active (bin = OFF)
• indicated in cm or inch
setting range
LK8022
LK8023
LK8024
Min-Max memory:
• HI: Displays the highest measured level
• LO: Displays the lowest measured level
Erase the memory
- Press the "Mode/Enter" button until "HI" or "LO" is displayed.
- Press the"Set" button and keep it pressed until "- - -" is displayed.
- Then press the "Mode/Enter" button briefly.
Offset (basic value for display and measured value):
The area between the bottom of the vessel and lower face of the measuring probe can be
entered as offset value. Thus the display and switch points refer to the real vessel level.
setting range
LK8022
LK8023
LK8024
Enhanced functions
This menu item contains a submenu with additional parameters. You can access these
parameters by pressing the SET button briefly.
Binary Mode
2 options can be selected: on = binary mode is active (→ page 21)
Display unit:
2 settings can be selected: EU = display in cm (Europe)
Select the display unit before setting the switch points (SPx, rPx).
This avoids rounding errors generated internally during the conversion of the units and enables
exact setting of the values.
Switching functions of the transistor outputs:
OU1 ... OU4 are active only if binary mode is not active (bin = OFF)
4 settings can be selected: Hno = hysteresis / normally open
All manuals and user guides at all-guides.com
→

Programming menu

cm
2.5 ... 20.5
4.0 ... 41.5
6.0 ... 61.0
Values for OFS = 0; with OFS > 0 the OFS value is added to these values.
cm
0 ... 78
0 ... 57
0 ... 186
OFF = binary mode is not active
inc = display in inch
Hnc = hysteresis / normally closed
Fno = window function / normally open
Fnc = window function / normally closed
page 3
inch
1.0 ... 8.0
1.4 ... 16.2
2.5 ... 24.0
inch
0 ... 30.6
0 ... 22.4
0 ... 74.5
in steps of
0.5cm / 0.2inch
0.5cm / 0.2inch
1.0cm / 0.5inch
in steps of
0.5cm / 0.2inch
0.5cm / 0.2inch
1.0cm / 0.5inch
Page 29