Mounting And Operation; Maintenance And Inspection - HIKOKI WH 18DA Bedienungsanleitung

MOUNTING AND OPERATION

Action
Removing and inserting the battery
Charging
How to use the LED light
Mounting the bit
Reversing the rotational direction
Switch operation
Remaining battery indicator
Mounting and removing the hook
(sold separately)
Selecting accessories
LED LIGHT WARNING SIGNALS
This product features functions that are designed to protect
the tool itself as well as the battery. If any of the safeguard
functions are triggered during operation, the LED light will
blink as described in Table 3. When any of the safeguard
functions are triggered, immediately remove your fi nger
from the switch and follow the instructions described under
corrective action. (Fig. 9)
Safeguard
LED Light Display
Function
Overload
On 0.25 second/
Protection
off 0.25 second
Low Voltage
Protection

MAINTENANCE AND INSPECTION

1. Inspecting the driver bit
Using a broken bit or one with a worn out tip is dangerous
because the bit can slip. Replace it.
2. Inspecting the mounting screws
Regularly inspect all mounting screws and ensure that
they are properly tightened. Should any of the screws be
loose, retighten them immediately. Failure to do so could
result in serious hazard.
3. Maintenance of the motor
The motor unit winding is the very "heart" of the power
tool. Exercise due care to ensure the winding does not
become damaged and/or wet with oil or water.
4. Inspection of terminals (tool and battery)
Check to make sure that swarf and dust have not
collected on the terminals.
On occasion check prior, during and after operation.
CAUTION
Remove any swarf or dust which may have collected on
the terminals.
Failure to do so may result in malfunction.
5. Cleaning on the outside
When the impact driver is stained, wipe with a soft dry
cloth or a cloth moistened with soapy water. Do not use
chloric solvents, gasoline or paint thinner, for they melt
plastics.
Figure
3
4
5
6
7
8
10
11
―
Table 3
Corrective Action
Remove the cause of
the overload.
Recharge the
battery.
6. Storage
Store the impact driver and the battery in a place in
which the temperature is less than 40°C and out of reach
Page
of children.
NOTE
2
Storing lithium-ion batteries.
2
Make sure the lithium-ion batteries have been fully
charged before storing them.
2
Prolonged storage (3 months or more) of batteries with
2
a low charge may result in performance deterioration,
signifi cantly reducing battery usage time or rendering
3
the batteries incapable of holding a charge.
3
However, signifi cantly reduced battery usage time may
3
be recovered by repeatedly charging and using the
batteries two to fi ve times.
3
If the battery usage time is extremely short despite
repeated charging and use, consider the batteries dead
161
and purchase new batteries.
CAUTION
In the operation and maintenance of power tools, the
safety regulations and standards prescribed in each
country must be observed.
Important notice on the batteries for the HiKOKI
cordless power tools
Please always use one of our designated genuine
batteries. We cannot guarantee the safety and
performance of our cordless power tool when used with
batteries other than these designated by us, or when
the battery is disassembled and modifi ed (such as
disassembly and replacement of cells or other internal
parts).
GUARANTEE
We guarantee HiKOKI Power Tools in accordance with
statutory/country specifi c regulation. This guarantee does
not cover defects or damage due to misuse, abuse, or
normal wear and tear. In case of complaint, please send
the Power Tool, undismantled, with the GUARANTEE
CERTIFICATE found at the end of this Handling instruction,
to a HiKOKI Authorized Service Center.
9
English