Eldom DA24C Bedienungsanleitung Seite 5

HOW TO FILL
Be sure the iron is unplugged from the power supply and the burst of steam regulator is set
to position before filling with water.
Ordinary room temperature tap water can be used as well as distilled water. Do not use
mineral or overcalcified as well as water destined for batteries.
For filling the water reservoir use only specially designed container which shape is adjusted
to the shape of the water inlet. Never fill the iron directly from water tap. Remember not to
pour water over the maximum level indicator MAX on the water reservoir (11).
ANTI DRIP SYSTEM
Anti Drip function prevents the water from dripping out of the soleplate when the iron
temperature is to low to produce the steam.
Water and steam coming out of the iron during self cleaning are hot. There is a danger of
scald.
SPRAY
After filling the reservoir with water you can use the function of spraying film of water
onto the cloth by pressing the spray button (3)
USEFUL TIPS
- only use the tap or distilled water
- iron is equipped with the vertical base (12) that enables comfortable and stable position
- decreasing the temperature with the thermostat does not lead to immediate cooling
down the soleplate; you should wait until the light indicator goes on again,
- by dry iron the water reservoir can be empty, be sure that the burst of steam regulator is set
to position. Whole scale of the temperature can be used depending on the type
of the fabric. If the water reservoir is full the function of spray can be used,
- the iron must be stored in vertical position, unplugged, cooled down and without
the water inside,
- by working with low temperature only dry iron possible,
CLEANING AND MAINTANANCE
- before cleaning unplug the iron and wait until it cools down completely.
the iron cannot be immersed in water
- do not clean the iron with sharp, abrasive clothes or sponges because
it can damage the appliance
- the body of the iron and the soleplate should be cleaned with moist cloth and wiped
dry with clean cloth.
All manuals and user guides at all-guides.com
SELF CLEANING
We recommend using the function of soleplate self cleaning
SELF CLEAN that prevents scale built-up. To use that function:
- fill the water reservoir entirely with water
- connect the iron to the power supply and set
the thermostat(7) to MAX position
- after the indicator light(8) goes out unplug the iron
and hold it horizontally over the sink
- push and hold the self cleaning button (10) and shake
the iron
- after cooling the iron down wipe the soleplate with moist
cloth to remove possible dirt
5