Taking A Reading - Elcometer 138 Gebrauchsanleitung

R

5 TAKING A READING

5.1 BEFORE YOU START
1 Press the ON/OFF button to switch the meter on.
2 Open the protection cover.
5.2 SAMPLING METHODS
The following sampling methods are available:
• Drop: for a small amount of sample - this is the preferred method for these tests.
• Immersion: for a large amount sample.
• Scooping: for sampling part of a sample.
When using the Drop sampling method:
1 Put a few drops of the sample into the measurement call avoiding the
inclusion of bubbles.
Bubbles in the solution may cause the measurement to be inaccurate.
4
2 Close the protection cover.
Ambient air may cause the measurement values to fluctuate. To reduce
4
environmental interference, close the protection cover.
3 Read the value displayed when
Note: If a measurement result is out of the specified measurement range, the displayed measured value flashes.
en-9
J J
appears. illuminates when measured value is stabilised.
www.elcometer.com