Starmix T-C BL HEPA Bedienungsanleitung Seite 9

WARNING - If the dryer has been fitted with a filter, it will need to be replaced after 60,000
operations but will continue working for a further 15,000 operations but without the benefits of
the HEPA filter. At approximately 75,000 operations the red LED will be flashing on the window
positioned at the front of the cover and the unit will stop working until a replacement filter is fitted.
11
The sterilization function of UV-C lamp will be weakened after 3 years use, the UV-C lamp needs to be
replaced for maintaining proper function.
1. Remove the filter cover and filter shown in page 8.
2. Remove the two screws on the UV-C lamp cover and remove UV-C lamp cover and pull out the UV-C lamp wire
jack from the UV light board.(fig.11).
3. Insert the New UV-C lamp and replace the UV-C lamp cover tighten the two screws and replace the wire jack on
the UV-C lamp board.
ATTACHING UNIT
Replace the filter (shown in Page 8) and attaching unit on the wall mounting bracket (Shown in Page 7).
Note: On power up should the red LED continue to flash this means the filter is not fitted correctly and
needs to be refitted.
OPERATING LED LIGHT
LED Lighting for standard and Black Edition
Front Cover color Stand by Mode
White / Silver White LED ON
Black Edition Red LED ON
Filter Alert Lighting
Filter uses Light
White LED
From 60,000 uses
~74,999uses
Red LED
Location LED (blue)
White LED
75,000 uses ~until
replace new filter
Red LED
Location LED (blue)
(Applicable only for PEBBLE PLUS model which is equipped Air sterilizer option)
Working Mode
White LED fast mode
Red LED fast mode
Stanby / Sterilization mode
White LED ON /
White LED slow mode
Red LED flashing
OFF
White LED ON
slow mode
Red LED flashing
OFF
EN
UV-C lamp wire jack
Sterilization mode
White LED slow mode
Red LED slow mode
working mode
(sensing mode)
White LED ON
fast mode
OFF
ON
White LED ON
slow mode
Red LED flashing
Flashing
9