Cleaning And Care - BRAYER BR4262 Bedienungsanleitung

10 EN

CLEANING AND CARE

Attention!
Provide that the dust bin (13), the separator (18) and
the HEPA-filter (19) are always clean, because the
overall performance of the vacuum cleaner depends
on it.
• It is recommended to clean the dust bin (13) after
every use of the vacuum cleaner. Regularly clean the
separator (18) and the HEPA-filter (19).
• Remove the extension pipe (4), to do it, press and hold
the clamp (5).
• To remove dust and garbage place the dust bin (13)
above the garbage bin, press the clamp (15) and open
the lid (16), remove the garbage and dust and close
the lid (16) until the clamp (15) clicking.
Cleaning the dust bin
• Before disassembling the dust bin (13) remove dust
and garbage from it as described above.
• Press the release button (6) and remove the dust bin
(13) (pic. 8).
• Remove the separator (16) from the flask (12) (pic. 9).
• Remove the HEPA filter (19) from the separator (18)
(pic. 10).
• Wash the separator (18) and the HEPA filter (19)
under a warm water jet and dry them (pic. 11, 12). Do
not dry the HEPA filter (19) with a hairdryer or similar
appliances.
• Wash the dust bin flask (17) and dry it (pic. 11).
• Do not wash all removable parts in a dishwashing
machine.
Note: before assembling the dust bin (13) make sure that
all removable parts are clean and dry.
Assembling of the dust bin
• Insert the HEPA filter (15) in the separator (16).
• Install the separator (18) in the dust bin flask (17).
• Install the assembled dust bin (13) in the installation
place until the clamp (6) clicking and make sure that the
dust bin (13) is fixed properly.
Cleaning the electric brush
• When using the electric brush (2) threads or long hair
etc. can wind up around the rotating brush. Keep the
electric brush (2) clean, disassemble the brush (2) and
clean the round brush as it becomes dirty.
• Remove the electric brush (2) from the extension pipe
(4) by pressing the release button (3).
• Turn the brush (2) over, slide the lock and remove it,
take out the round brush, remove the threads and hair
wrapped around the brush (pic. 13).
• Clean the inner and outer surface of the electric brush
(2) body from garbage and dust.
Assembling the electric brush
• Insert the left part of the round brush into the body.
• Install the right side of the round brush back to its place.
• Make sure that the round brush is fixed properly.