Assembling The Vacuum Cleaner; Cleaning And Maintenance - BRAYER BR4222 Bedienungsanleitung

8 EN
USING THE ATTACHMENTS
Universal pneumatic brush (1)
Universal brush is suitable for all surfaces.
Crevice nozzle (27)
The nozzle (27) is used for cleaning radiators, chinks or
spaces between cushions.
Furniture brush (28)
Use the attachment (28) to clean the furniture upholstery.
Attachment compartment
Press the attachment compartment lid clamp (12) and
open the lid. After use place the attachment in the
compartment and close the lid until the clamp (12) snaps.

ASSEMBLING THE VACUUM CLEANER

Attaching and removing the flexible hose (7)
• Insert the flexible hose (7) ending (8) into the air inlet
(10) until the locks (9) catch.
• To remove the flexible hose (7), press the locks (9) and
detach the ending (8) from the air inlet (10) (pic. 1).
Attaching the telescopic pipe (4) and the attachments
• Attach the telescopic extension pipe (4) to the flexible
hose handle (5) (pic. 2).
• Extend the lower part of the telescopic extension pipe
(4) to the required length, having preliminarily pressed
the lock (3) (pic. 2).
• Сhoose the desired attachment – floor/carpet brush (1),
crevice nozzle (27) or upholstery attachment (28) – and
attach it to the telescopic extension pipe (4).
• You can attach the attachments (27 and 28) to the
flexible hose handle.
ATTENTION!
• Do not use the vacuum cleaner in places where
aerosols are used or sprayed and in proximity to highly
inflammable liquids, do not use the vacuum cleaner in
the places where such liquids are stored.
• The vacuum cleaner is not intended for collecting water
or any other liquids; do not use it for collecting burning
or smoking cigarettes or cinders.
• Do not use the vacuum cleaner for collecting dust of
plaster, concrete, flour or ashes.
• Take sharp objects away from the floor before cleaning
to prevent damage to the unit.
• If the suction power of the vacuum cleaner decreases
rapidly while cleaning, switch it off immediately, unplug
it and check the telescopic pipe (4) or the flexible hose
(7) for obstruction. Remove the obstruction, after that
you can resume cleaning.
USING THE VACUUM CLEANER
Attention! You can turn the vacuum cleaner on only with
the installed dustbag (15 or the disposable paper dustbag
(29), as well as with the inlet filter (16) and the outlet
HEPA filter (23) and the foam filter (24).
• Before cleaning always make sure that the filters (16,
23, 24) are installed properly.
• Take the power plug and unwind the power cord to the
required length, connect the power plug to the mains
socket.
• The yellow mark on the power cord indicates the
maximum cord length. Do not pull out the power cord
further than the red mark.
• Press the on/off button (17) to switch the vacuum
cleaner on (pic. 4).
• While cleaning, you can control the suction power
using the manual suction power control (6) on the
flexible hose handle (5) and with the suction power
control buttons (19) «-/+» (pic, 5) on the display (17)
will show the the optimum suction power ratio and the
surface type for cleaning (pic. 6).
- minimum power level
- optimal power for cleaning curtains, etc.
- high suction power and low noise level
- carpets cleaning
- maximum suction power, extremely dirty floors and
carpets cleaning
• After you finish cleaning, switch the vacuum cleaner off
by pressing the on/off button (17) and unplug it.
• To wind the power cord, press the button (20); keep a
hold of the winding cord with your hand (pic. 7).
EN
• If you have to make a break during the cleaning, switch
the vacuum cleaner off by pressing the button (17) and
install the brush (1) to the brush storage (22).
ATTENTION!
Before changing the attachments or cleaning the dust
bin (15), switch the vacuum cleaner off by pressing the
on/off button (17) and unplug it.

CLEANING AND MAINTENANCE

Cleaning the dustbag (15)
• If during cleaning the full dustbag indicator (21) lights
up, empty the dustbag (15) or replace the disposable
paper dustbag (29).
Note: the paper dustbag (29) is disposable, when the
dustbag (29) is full, dispose of it.
• Before cleaning the dustbag (15), switch the vacuum
cleaner off by pressing the on/off button (17) and unplug
it.
• Open the dustbag compartment lid (13) by pressing the
lid lock (11) (pic. 8).
• Remove the dustbag holder (14) with the dustbag (15)
(pic. 9).
• Take the dustbag (15) out from the holder (14).
• Place the dustbag (15) above the garbage bin, remove
the plastic clamp and clean the dustbag (15) of garbage
and dust. You can wash the dustbag (15) with warm
water and soft detergent, rinse and dry thoroughly. After
that install the plastic clamp on the dustbag (15).
9