Gaggenau AC230101 Gebrauchs- Und Montageanleitung Seite 39

Push the side covers inwards and remove them.
4.
Close the odour filter cartridge.
5.
Hanging the appliance
Lift the appliance by the corners and turn it over.
1.
Position the cable that is provided on-site in the
2.
marked area on the appliance.
Guide the cable that is provided on-site through the
3.
opening and hook the appliance into the fastening
screws on the ceiling.
4. Push the appliance as far as it will go into the four
key hole openings using the guide sleeves.
All manuals and user guides at all-guides.com
5.
6.
Connecting the appliance
Requirement: Ensure that the protection against con-
tact is guaranteed during installation.
1.
2.
Installing covers
Components inside the appliance may have sharp
edges.
▶
Move the appliance and lower it further so that the
collar nuts are positioned on the edge of the guide
sleeves.
Carefully tighten the diagonally opposite collar nuts
until the appliance is flush-mounted on the ceiling.
13
Tighten the collar nuts one at a time so that the ap-
pliance does not tilt when doing so.
Guide the cable that is provided on-site through the
opening in the appliance.
Maintain the bending radius of the cable that is
provided on-site for connecting the appliance.
The cable must remain doubly insulated. You should
therefore strip the cable as little as possible up-
stream of the connecting terminal.
Insert the on-site cable into the terminal plug.
WARNING ‒ Risk of injury!
Wear protective gloves.
Installation instructions en
39