Electrical Safety - VONROC MS505AC Bersetzung Der Originalbetriebsanleitung

Vorschau ausblenden

Inhalt

Inhaltsverzeichnis

Verfügbare Sprachen

work with your hand into the blade.

• Let the blade reach full speed before contact-

ing the workpiece. This will reduce the risk of

the workpiece being thrown.

• If the workpiece or blade becomes jammed,

turn the mitre saw off. Wait for all moving parts

to stop and disconnect the plug from the power

source and/or remove the battery pack. Then

work to free the jammed material. Continued

sawing with a jammed workpiece could cause

loss of control or damage to the mitre saw.

• After finishing the cut, release the switch, hold

the saw head down and wait for the blade to

stop before removing the cut-off piece. Reach-

ing with your hand near the coasting blade is

dangerous.

• Hold the handle firmly when making an incom-

plete cut or when releasing the switch before

the saw head is completely in the down posi-

tion. The braking action of the saw may cause

the saw head to be suddenly pulled downward,

causing a risk of injury.

• Keep your work area clean. Material mixtures

are particularly hazardous. Light metal dust may

catch fire or explode.

• Do not use dull, cracked, bent or damaged saw

blades. Unsharpened or improperly set saw

blades produce narrow kerf causing excessive

friction, blade binding and kickback.

• Do not use saw blades made from high speed

steel (HSS). Such saw blades can easily break.

• Always use saw blades with correct size and

shape (diamond versus round) of arbour holes.

Saw blades that do not match the mounting

hardware of the saw will run off-centre, causing

loss of control.

• Do not replace the integrated laser with a laser

of another type. A laser that is not compatible

with this power tool could pose a risk to persons.

• Never remove cuttings, wood chips, etc. from

the cutting area while the power tool is running.

Always guide the tool arm back to the neutral

position first and then switch the power tool off.

• Do not touch the saw blade after working before

it has cooled. The saw blade becomes very hot

while working.

• Never make warning signs on the machine

unrecognisable.

• If laser radiation hits your eye, you must close

your eyes and immediately turn your head away

from the beam.

WWW.VONROC.COM

• Do not use any optical instruments such as

binoculars to view the radiation source. Doing

so can damage your eye.

• Do not direct the laser beam at persons who

are looking through binoculars or similar in-

struments. Doing so can damage their eye.

• Do not make any modifications to the laser

equipment. The setting options described in

these operating instructions can be used safely.

• Do not stand in line with the saw blade in front

of the power tool. Always stand to the side of

the saw blade. This protects your body against

possible kickback.

• Keep hands, fingers and arms away from the

rotating saw blade.

• Do not reach one hand across the other when in

front of the tool arm.

• Avoid overheating of the saw teeth. When the

saw blade overheats, stop the machine. Allow

the saw blade to cool down before using the

machine again.

• Replace damaged or worn saw blades im me-

dia tely.

• Only use saw blades that match the specifica-

tions given in this operating manual and that

have been tested and marked in accordance

with EN 847-1.

• When sawing curved or round workpieces,

these must be especially secured against slip-

ping. At the cutting line, there should be no gap

between the workpiece, fence and saw table. If

necessary, you will need to manufacture special

fixtures.