Operation; Maintenance; Troubleshooting - VONROC MS505AC Bersetzung Der Originalbetriebsanleitung

EN

4. OPERATION

Using the mitre saw (Fig. A)
Before use, always check for faults or
defects!
• Set the desired sawing angle of the machine.
• Put the plug into the socket.
• Fix the piece of work in place using the clamp
(7): make sure that the material is well clamped
in place!
• Hold the material tightly on the left side while
making sure that you keep a safe distance from
the blade of the saw.
• To start the machine, press and hold the Lock-
off button (3) and press the on/off switch (1).
• Make sure that the saw blade has reached full
speed before allowing it to touch the piece of
work to be sawn.
• Now bring the saw slowly downwards so that
the saw blade saws through the piece of work
and passes through the slot in the table. Do not
put any pressure on the saw. Give the machine
time to saw through the piece of work.
• Bring the machine gently up again and switch it
off by letting go of the switch (1).
Using the slide-function (Fig. A)
The machine must be firmly bolted to a
workbench.
Use the slide-function for sawing wide workpieces:
• Fix the piece of work in place using the clamp.
• Loosen the knob (12).
• Slide the machine completely towards yourself.
• Turn on the machine using the switch.
• Bring the saw slowly downwards so the saw
blade saws through the piece of work.
• Push the machine slowly backwards.
• Bring the machine gently up again and switch it
off by letting go of the switch.
Using the laser (Fig. B)
• To switch on the laser, press the on/off switch (2).
• To switch off the laser, release the on/off switch
(2).
Transport position
When moving the saw, make sure the saw is in
inward position. Check that all locks and tensioning
devices are secure:
10
• Make sure the mitre angle is set to 0°.
• Make sure the bevel angle is set to 0°.
• Lock the Knob adjusting saw angle (9) by turn-
ing it clockwise.
• Slide the machine completely towards yourself.
• Lock the sliding function by turning Kob over
sliding support (12) clockwise.
• Unlock the Lock pin (5) on the right hand side of
the machine.
• Push the machine completely downwards.
• Lock the Lock pin (5) on the right hand side of
the machine.
Only lift the machine by the solid underside of the
machine. Do not lift the saw by the switch handle.

5. MAINTENANCE

Always make sure that the machine is not
connected to the mains electricity when you
carry out any maintenance of the mechanism.
Slide rails
Dirt can damage the slide rails and thereupon the
operating of the machine.
• Clean the slide rails regularly with a soft cloth.
• Drip some lubricating oil on the slide rails.
• Move the mitre saw forwards and backwards so
the oil spreads over the complete rails.
These machines are designed to function for a
long time without any problems with a minimum
of maintenance. By cleaning the machine regularly
and using it in the correct way you can contribute
to a long life of your machine.
Cleaning
Clean the machine housing regularly with a soft
cloth, preferably after each time you use the ma-
chine. Make sure that the ventilation slots are free
of dust and dirt. For stubborn dirt use a soft cloth
dampened with soapy water. Never use solvents
such as benzene, alcohol, ammonia, etc. These
types of solvents can damage the plastic parts.

TROUBLESHOOTING

1. The motor does not start
• The plug is not in the socket.
• The power cord is broken.
• The switch is defective.
WWW.VONROC.COM