Hendi PROFI LINE 208533 Gebrauchsanweisung Seite 6

Brewing coffee
NOTE: To brew coffee with this appliance, a cof-
fee filter is required. Coffee filters Ø 25cm (x10,
supplied). Do not use this appliance without cof-
fee filter in place.
To make coffee follow these steps:
1. Put the coffee filter (supplied) inside the filter
pan. Add the desired amount of ground coffee,
depending on your taste. The recommended
amount is 75-90 gm per pot of water (1.6-1.8
litre).
2. Place the filter pan in the holder.
3. Fill the coffee pot (glass decanter, vacuum pot
or thermos depending on model type) with the
desired amount of water and pour it in the wa-
ter reservoir. Then, close the lid of the water
reservoir.
4. Place the empty glass decanter on the lower
warming plate.
5. Connect the power plug to a suitable electrical
power outlet.
6. Press the once to switch ON the appliance
and RED indicator lights up to indicate that the
brewing process has started.
EN
7. After some time coffee will start to drip into
the coffee pot.
8. When all of the water has passed through the
machine, the
and go into keep warming mode. Brewing cof-
fee process finished. The coffee is ready to be
served.
9. In order to keep warming of the glass decant-
er, the appliance must remain switch ON.
10. When served, remove the glass decanter
from the warming plate and pour the cof-
fee carefully to ensure that hot coffee is not
spilled. Hold the handle of the glass decant-
er only. Danger of burns!
6
button will change to BLUE
11. It takes about 5 to 6 minutes to brew one
glass decanter of coffee.
12. There is another warming plate at the top.
You can put the ready glass decanter on it &
press keep warming button
keep it warm. So that you can brew another
glass decanter of coffee at the same time us-
ing the lower warming plate.
13. The appliance has an overflow tube to allow
extra water in the reservoir to escape, but
since the coffee pot can hold only 1.8 litres of
water we recommend that you never fill the
reservoir with more than 1.8 litres of water.
14. Some water will always be left in the machine
and in the tubes. If you do not use or move the
appliance for a long time, it is best to empty
the appliance and clean it before storing it.
15. If you have emptied the appliance (as rec-
ommended in no. 10 above), before using it
again you should repeat steps 1-7 of Prepar-
ing the appliance for use.
16. If you haven't used the appliance for a short
time, rinse it out with clean water before use.
NOTE: There is a RED indicator lamp at the low-
er front side. It will lights up when temperature
safety device is activated for protection due to
abnormal operation. Unplug it and left cool down
completely. Contact the supplier.
Do not forget to turn the appliance off after use.
to operate &