Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Mounting
If you are working with a stone wall, drill the
marked two 5 mm holes and insert the plugs sup-
plied. If you are working with a wooden wall, you
can pre-drill 1.5 mm holes to make screws easier
to insert.
•
Use the supplied screws and plugs (L) to fasten
the mounting plate to the wall (see figure 4).
Attach the clip-on frame (A) to the mounting
•
plate.
Place the electronic unit (B) back into the frame
•
(see figure 1). Make sure that the clips on the
mounting plate latch into the openings on the
electronic unit.
Information about installation on flush-mounted boxes:
•
For installation on a flush-mounted box, please
use the bore holes (K) (see fig. 3)
Please note! Only to be installed by persons with
the relevant electro-technical knowledge and ex-
perience!*
Incorrect installation can put
•
your own life at risk;
•
and the lives of other users of the electrical system.
38
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
