Before Installation; Location Of The Shaker; Voltage - GFL 3005 Bedienungsanleitung

Schüttelapparate - Shakers
3005 / 3006 / 3011 / 3013 / 3015 / 3016 / 3019 / 3023

1. Before installation

The information in these operating instructions must by all means be carefully read and
observed. Only then can a perfect operation of the Shaker be guaranteed.
A free of charge guarantee repair cannot be granted for defects due to improper installation or
handling.
In some Shaker types, a paperboard strip has been inserted as a transport protection between
shaking table and housing. The paperboard strip must be removed before installation.

2. Location of the Shaker

The unit is suitable for bench mounting indoors and for use in incubation and tempering rooms.
Place on solid, stable and level surfaces only. Please observe the total admissible weight (weight
of the unit as per Technical Data – item 7 of these operating instructions – plus load).
For use in incubation and tempering rooms please observe the environmental conditions stated
in the Technical Data.
The Shaker is not suitable for use in explosion endangered surroundings, eg during
anaesthesia with inflammable gas or steam types!

3. Voltage

The right-hand control knob of the Shaker must be in 0 position.
The voltage on the nameplate (at the back of the unit)
must be identical to the mains voltage.
If they are identical, connect the unit to the mains: Plug
the appliance plug into the unit socket at the back of the
Shaker and the shock-proof plug into the mains socket.
Vital information within the manual are emphasized in bold
letters. Safety precautions are additionally marked with the
following symbols
Warning of dangerous electrical voltage
Seite 8 Rev5 vom /dated 27.10.2014
Warning of hand injuries
General hazard warning