EUROM OK115T Handbuch Seite 28

Prevent unexpected starting: check that the switch is OFF before you insert the
plug into the socket.
Use the heater for its intended purpose only. Do not make any changes or
connect anything to it. If you are not sure of whether the heater can be used, contact
your supplier or the importer.
Only have your heater repaired by a qualified person: the heater fulfils safety
requirements. That is why repairs must only be carried out by a suitable, qualified
individual, using original parts. Deviations from this regulation will invalidate the
guarantee and the supplier and manufacturer will no longer be liable for any
consequences.
And also:
 Every time you use it, check that the heater is in good condition and is working
properly. Have damaged parts repaired or replaced immediately.
 Only connect the heater to a socket which corresponds to the voltage and
frequency that is stated on the heater's specification plate. Only use an earthed,
3-pin socket. If you have to use an extension cable, make sure it is of the
appropriate thickness!
 Only use paraffin or diesel in your heater, in accordance with the instructions in
this booklet.
 Keep the front of the heater at least 5 metres from any flammable materials such
as wood, plastic, paper, tent cloth, etc and the back and top at least 3 metres, the
side 2 meters from this type of material.
 Always position the heater on a flat, stable and horizontal surface.
 Do not use the heater in the vicinity of flammable materials, liquids, gases or
pressurised gas pipes.
 Do not use the heater in an enclosed space, living area, ground floor, cellar or
space under ground level.
 If using in locations with (too) little ventilation, too much moisture etc, special
measures must be taken in relation to the supply and removal of air, soot,
extinguishing etc. Consult a qualified expert in this instance.
 Do not allow untrained, inexperienced people to operate the heater and do not
allow it to be operated unless all covers, lids and so on have been correctly
installed.
 Never move the heater and do not touch if it is in operation or is still hot. Unplug
and then leave to cool.
 Never transport the heater with fuel in the tank!
 Do not damage the electrical cable. Do not tilt the heater using the cable and do
not pull on the cable to remove the plug from the socket. Keep the cable away
from heat, oil and sharp edges. Do not use the heater if the cable is damaged but
make sure it is replaced by your supplier or a recognised electrician in order to
prevent risks.
 Never leave a working heater unsupervised; unplug the device when leaving the
workspace. Do not switch the heater off by removing the plug from the socket;
28