TFA VIEW SHOW Bedienungsanleitung Seite 23

6.4.2 NAP function
Press and hold the NAP button (Fig.2-J) for 3 seconds in normal mode to set the NAP function.
y
30 minutes (default setting) is flashing.
y
Press the + or - button (Fig.2-F+G)to set the NAP interval (5 to 120 minutes).
y
y Confirm the setting with the NAP button.
After setting a new NAP duration, the NAP function is activated directly.
y
y NAP appears in the upper display next to the time when the NAP function is activated. The remaining duration of the nap time is displayed
and counts backwards.
When the adjusted nap time is reached, the alarm rings.
y
The alarm sound automatically turns off after 2 minutes if not stopped manually.
y
Press any button to stop the alarm and the NAP function.
y
By pressing the NAP button in normal mode, the NAP (short sleep) function can be reactivated at any time with the set duration.
y
6.5 Projection function
You can rotate the projection display by 270° with the dial (Fig.3-B).
y
The projection arm (Fig.3-A) can also be tilted slightly forwards and backwards to adjust the projection position on the ceiling.
y
If you press the button (Fig.2-C) once briefly in normal mode, you can adjust the brightness of the projection in 3 steps or deactivate
y
the projection completely ("OFF").
If you press the PROJ INFO button (Fig.2-D) once briefly in normal mode, you can switch through the available options for the projection
y
display. The last selected option will remain permanently active.
y The sequence of the available options in this mode is shown as follows:
Time (always available)
y
y Regional outdoor temperature (only available with active online connection)
Extra sensor 1 (only if installed)
y
y Extra sensor 2 (only if installed)
Extra sensor 3 (only if installed)
y
Extra sensor 4 (only if installed)
y
Indoor temperature and humidity (always available)
y
The selected option is also briefly shown in the time area or in the text display (with the current measured value and sensor ID,
y
if available).
If you press and hold the "PROJ INFO" button for 3 seconds in normal mode, you can activate an automatic change of the projection
y
display between time and another option.
The display shows PROJ ALT/WITH and TIME OFF flashes. Press the + or - button (Fig.2-F+G) to select TIME ON.
y
y Confirm the setting with the PROJ INFO button.
If PROJ IN CHANGE + TIME ON is selected, the projection display will automatically change between the permanently selected display
y
option and the time every 8 seconds.
6.6 Indoor climate comfort level (only displayed without online connection)
Based on the current indoor humidity, the comfort level is displayed in 5 levels:
y
WET (flashing)
y
WET (permanent)
y
OK (permanent)
y
y DRY (permanent)
DRY (flashing) )
y
6.7 USB charging function
Plug your charging USB cable into the USB port (Fig.3B) on the alarm clock and connect the other end to your mobile device. Make sure
y
that the USB charging function is suitable for your mobile device (charging current 1A).
y Do not apply excessive force when connecting the USB cable. The USB plug fits only one way into the USB port.
> 75 rH
60 bis 74% rH
40 bis 59% rH
25 bis 39% rH
< 24% rH
23