General Information; Tuning To Radio Stations - Philips AZ-2030 Bedienungsanleitung

GENERAL INFORMATION

General maintenance
• Do not expose the set, batteries, CDs or cassettes to humidity,
rain, sand or excessive heat caused by heating equipment or
direct sunlight.
• To clean the set, use a soft, slightly dampened chamois leather.
Do not use any cleaning agents containing alcohol, ammonia,
benzene or abrasives as these may harm the housing.
Safety information
• Place the set on a hard and flat surface so that the system does
not tilt. Make sure there is adequate ventilation to prevent the
system from overheating.
• The mechanical parts of the set contain self-lubricating bearings
and must not be oiled or lubricated.

TUNING TO RADIO STATIONS

1. Select TUNER source.
™
is displayed briefly and then the radio station
frequency, waveband and, if programmed, a preset number is
shown.
2. Press BAND once or more to select your waveband.
3. Press SEARCH ∞ or § (for AZ2035 model only: or on the
remote control TUNING ∞ or §) and release when the
frequency in the display starts running.
™ The tuner automatically tunes to a station of sufficient
reception. Display shows
™ If a FM station is received in stereo,
4. Repeat step 3 if necessary until you find the desired station.
• To tune to a weak station, press SEARCH ∞ or § briefly and
repeatedly until you have found optimal reception.
To improve radio reception
– For FM, pull out the telescopic aerial. Incline and turn the aerial.
Reduce its length if the signal is too strong (very close to a
transmitter).
– For MW (AM/LW), the set is provided with a built-in aerial so
the telescopic aerial is not needed. Direct the aerial by turning
the whole set.
All manuals and user guides at all-guides.com
during automatic tuning.
is shown.
STEREO
AZ 2030-2035/17
DIGITAL TUNER
A M
BATT
LOW
7