Preparation Of The Surface; Assembly The Machine; Operation; Exchange Adjustment Of Fingers - HOLZMANN-MASCHINEN AKM610ECO Betriebsanleitung

13.2 Preparation of the surface

Remove the conservation agent that is applied to protect the parts against corrosion without
painting. This can be done with the usual solvents. Do not use nitro solvents or similar agents
and under no circumstances use water.
The use of paint thinners, petrol, aggressive chemicals or abrasive cleaners leads to
material damage to the surfaces!
The following therefore applies: Use only mild cleaning agents for cleaning

13.3 Assembly the machine

The machine is supplied pre-assembled and it is only necessary to fix it on its place of installation
before use.
14

OPERATION

Only operate the machine in perfect condition. Before each operation, carry out a visual
inspection of the machine. Safety devices and operating elements must be checked carefully.
Check screw connections for damage and firm seating.
The sharp edges of metal sheets can cause cuts during handling. Suitable protective
gloves and simple aids (hand magnets, hand vacuum cleaner, carrying clamps,
carrying claws) can prevent these injuries.
14.1 Operation

14.1.1 Exchange adjustment of fingers

HOLZMANN MASCHINEN GmbH
N O T I C E
C A U T I O N
The fingers can be arranged at a distance from each
other for the production of trays or boxes. To do this,
you must remove one or more of the fingers so that
you can keep the others at a distance according to the
inside width of your tray or box.
Procedure:
1. loosen the socket head screws from each finger you
need to remove.
2. remove the fingers and clamps from the clamp and
set them aside.
Note: Fingers must be assembled to match the inside
width of your workpiece.
3. align the remaining fingers and tighten the cap
screws.
www.holzmann-maschinen.at
Hole pattern of the fixing holes.
OPERATION
19
AKM610ECO