System Configuration - Musway M12 Bedienungsanleitung

SYSTEM CONFIGURATION

In order to configure the inputs, amplified speaker outputs and pre-amplified power outputs, EQ and time
delays for the amplifier, it must be interfaced with the PC. When you get to this point you must already be
aware of what type of system you intend to set up. In order to avoid complications in preparation, make sure
the following points before you start:
• The type of signals that will be assigned to the inputs (e.g.: front left or center or subwoofer, etc.).
• The speakers in the system (e.g.: 3-way front or sub stereo or 2-way rear, etc.).
• If there are passive crossovers that manage groups of speakers (e.g.: 3-way systems with active
midrange).
• If you intend to use an external mono amplifier to drive a subwoofer.
• If you intend to use the amplified outputs of the amplifier bridged (BLT mode), thus increasing the power on
the output.
INITIAL SYSTEM START-UP
• Download and save the
amplifier to your personal computer.
• Install the amplifier in your vehicle before you connect a computer to it.
• Turn the ignition key to the ACC or ON position.
• Connect a PC/Laptop with the USB terminal of amplifier by using the enclosed USB cable.
• After you have open the DSP software, you can set/adjust all the audio settings on the computer.
• The amplifier is on when the logo on the top lights up in orange. After 10 seconds it becomes operative.
WARNING
Before turning on the system, set the head-unit output level to a lower level (approximately
20% of its maximum excursion) to avoid damaging the speakers during calibration.
Check again carefully the configuration of the crossovers , the speakers setup. Wrong type
of crossover or inappropriate parameter may cause permanent damages on the speakers,
especially tweeters without passive crossovers.
MUSWAY DSP V3.x software via "www.musway.de/dsp" before connecting the
ENGLISH
11