Musway M12 Bedienungsanleitung Seite 10

ENGLISH
FUNCTIONAL CONTROLS
11 12
14
USB
11
This USB input is suited for the connection with a PC/laptop computer, where the
software is installed. The connection is USB 1.1/2.0/3.0 compatible. For downloading the software
please visit "www.musway.de/dsp".
TURN ON SEL
12
The amplifier can be turned on/off by using the following methods:
SPK: Slide the switch into position SPK, if you want to turn on/off the amplifier through
the CH1 input channel of the high level speaker inputs and its Auto Turn-On function.
Refer to page 8 and section 4 for more details.
REM: Slide the switch into position REM, if you want to turn on/off the amplifier through
the REM and a turn-on signal from head unit / car stereo.
Refer to page 8 and section 3 for more details.
SENSITIVITY AUX, CH1-6 & CH7-12
13
With these controllers you can adjust the input sensitivity for each input section separately. This func-
tion is suited to match the output voltage of the connected signal source with the amplifier.
DRC
14
This input is suited for the external
"www.musway.de" for more information or ask your car audio retailer.
CLIP
15
This LED lights up red if one of the high level inputs (CH1-6 & CH7-12) is overdriven. The LED has no
function when an input signal is applied to the Optical input and the Bluetooth
up, reduce the input sensitivity by using the regarding "Sensitivity" controller until the LED goes out.
10
13
15
MUSWAY DRC1 digital remote controller. Check the website
input. If this LED lights
®
MUSWAY DSP V3.x