Accessories - Velleman DVM851 Bedienungsanleitung

To replace the battery or fuse:
 Switch of the meter
 Remove the protective edge, release the two screws located at the
backside of the meter and gently open the housing.
 Remove the old battery and insert a new one.
Battery: 9V 6LR61 alkaline, do not use rechargeable batteries and
make sure to respect the polarity
Fuses: F500mA 600V and F10A 600V 5x20mm
Make sure the meter is closed tight and put the protective edge back
in place before using the meter.
Troubleshooting
If the device beeps continuously while measuring continuity, this
means that the 600V-500mA internal fuse is defective. Replace this
fuse.
Keep in mind that a low battery level could lead to incorrect
measurements. Replace the 9V battery on a regular basis.
(tip: the reduced luminosity of the backlight/LCD display indicates a
low battery level)

Accessories

 Meter with protective holder (edge)
 User manual
 Set of test leads
 9V battery
 Transistor socket
Use this device with original accessories only. Velleman nv cannot
be held responsible in the event of damage or injury resulting from
(incorrect) use of this device. For more info concerning this product
and the latest version of this manual, please visit our website
www.velleman.eu. The information in this manual is subject to
change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All
worldwide rights reserved. No part of this manual may be copied,
reproduced, translated or reduced to any electronic medium or otherwise
without the prior written consent of the copyright holder.
V. 03 – 23/10/2015
DVM851
14 ©Velleman nv