Mounting The Loop Handle; Adjusting Trimmer For User; Adjusting Length Of Shaft - Stihl FSE 52 Gebrauchsanleitung

English
1
2
3
► Thread the ends of the nylon lines (4) from the
spool (2) through the openings (1) in the mow‐
ing head (5).
► Insert the spool (2) in the mowing head (5).
► Fit the cover (7) on the mowing head (5) so
that its tabs (3) line up with the openings (6) in
the mowing head (4).
► Push the cover (7) onto the mowing head (5)
as far as stop.
The tabs (3) engage audibly.
6.2.2 Removing the Mowing Head
Trimmer with fanwheel
► Switch off the trimmer and disconnect exten‐
sion cable's coupling from trimmer's plug.
► Hold fanwheel (2) steady with one hand.
► Unscrew the mowing head (1) counterclock‐
wise.
► Remove the fanwheel.
Trimmer without fanwheel
The trimmer comes with the AutoCut 2-2 mowing
head already mounted and cannot be removed
by the user.. The spool can be removed by the
user.
► Switch off the trimmer and disconnect exten‐
sion cable's coupling from trimmer's plug.
24
4
5
6
7
1
2

7 Adjusting Trimmer for User

1 1
► Press in the tabs (1) and remove the cover (3).
► Remove the spool (2).
6.3

Mounting the Loop Handle

► Switch off the trimmer and disconnect exten‐
sion cable's coupling from trimmer's plug.
2
1
► Line up the loop handle (2) so that the recess
for the star knob nut (1) is on the right of the
control handle and the openings in the loop
handle (2) are facing the operator.
► Ease the ends of the loop handle (2) apart and
push it onto the control handle until it engages
in position.
► Insert the screw (3) through the hole.
► Fit the star knob nut (1) and tighten it down.
The loop handle (2) must not be removed again.
7 Adjusting Trimmer for User
7.1

Adjusting Length of Shaft

The length of the shaft can be adjusted to suit
the height and reach of the user.
► Switch off the trimmer and disconnect exten‐
sion cable's coupling from trimmer's plug.
► Hold the shaft firmly.
1
2
2
3
3
0458-777-9621-B