Delayed Start; Starting The Dishwashing Programme; Unloading The Dishwasher - hanseatic HG6085D14J7635EI Gebrauchsanleitung

Delayed start

(6)
The wash cycle normally starts as soon as
you press the button (11).
If you want the cycle to begin later, you can
specify this. The start time can be delayed
between 1 and 24 hours.
• Press the plus or minus button
as often as required until the display (10)
shows the desired start-delay (
to H:24 ).
Starting the dishwashing
programme
(6)
4. Start the programme with the
ton (11). If you have
– not set up a start delay, the programme
cycle will begin after a few seconds.
– set up a delayed start, the display will
initially still show the start-delay du-
ration (6); the dots between
number of hours will flash. After the start
delay runs out, the programme will start.
During the programme the display will
show the time remaining (6); the dots be-
tween hour and minute numbers will flash.
At the end of the programme cycle, an
acoustic signal will sound 8 times and the
end
display will show .
Dishwasher operation
5. Switch the dishwasher off using the
button (18).
6. Turn the tap off.
7. Wait a little while before unloading the
dishwasher.

Unloading the dishwasher

(12)
CAUTION!
Risk of scalding!
If you open the appliance door, hot
steam will come out.
Maintain a suffi cient distance from
■
(12)
the appliance door and do not hold
your head or upper body directly
H:00 H:01
,
above the open appliance door.
Make sure that children do not open
■
the appliance door if the programme
has only fi nished a short time ago.
Only open the appliance door slight-
■
ly to allow the steam to escape more
easily.
Allow the dishes to cool before un-
■
loading the dishwasher.
Risk of injury!
An open appliance door can quickly be-
(11)
come a tripping hazard.
Close the appliance door after every
■
but-
use.
Only leave the appliance door slightly
■
open to cool down.
H and the
NOTICE
Risk of damage!
Make sure that children and pets
■
do not stand on the open appliance
door.
Page EN-23