ECG VT 5220 2in1 Flex Clean Bedienungsanleitung Seite 9

Pulling out and refreshing the
filter
Open the dust container lid by turning
it counterclockwise. Remove the foam
inlet filter from the top of the dust
container. Rinse the filter together with
the holder and allow it to dry naturally
before putting it back into the vacuum
cleaner.
Note: The dust container cannot be
washed with water as it contains
conductive parts.
Dust container assembly
1. Insert the assembled filter into the
dust container by aligning the three
position marks on the filter and
the dust container. The foam filter
belongs on the top.
2. Holding the vacuum cleaner body,
align the mark on the dust container
with the locking mechanism and
turn the container towards the mark
clockwise.
3. Insert the dust container by inserting the positioning hook into the hole at the bottom and turn it. A
proper insertion in place will be accompanied by an audible click.
Positioning
hook
Cleaning the vacuum cleaner
Make sure before cleaning that the vacuum cleaner is not connected to the charger.
Use soft and slightly moist cloth with a few drops of detergent to clean the vacuum cleaner. Never use solvents
or other abrasive cleaners.
Never immerse the vacuum cleaner or the adapter in water or any other liquid and do not place it under
running water.
Locked
Hole in the
vacuum cleaner
body
HEPA filter
Filter
Unlocked
Outer seal Inside seal
9