Using The Vacuum Cleaner - Concept VP9231 Bedienungsanleitung

EN
OPERATING INSTRUCTIONS - ASSEMBLING THE VACUUM
CLEANER
NOTE:
Always disconnect the plug from the mains outlet prior to mounting or removing
accessories!
1. Connecting the flexible hose to the vacuum cleaner
Insert the flexible hose into the air suction inlet of the vacuum cleaner (Fig. 1).
Continue pushing until you hear a clicking sound, which indicates that the correct
position has been reached.
To remove the flexible hose, push both safety buttons and remove the hose.
The suction power can be controlled on the hose handle.
Slide controller in closed position – stronger air flow.
Slide controller in open position – weaker air flow.
2. Attaching the telescopic tube to the hose adapter
Place the telescopic tube on the hose adapter and turn slightly.
3. Extending the telescopic tube
Press the plastic latch and extend the smaller tube outwards.
4. Putting the floor attachment on the telescopic tube
Insert the telescopic tube into the floor attachment and turn slightly.
The flap (Fig. 2) allows setting the floor attachment to brushing (for flat floors) or to
smooth vacuuming (for carpets).
ACCESSORIES
The carried accessories are kept in the unit's body, under the cover.
1. Slotted nozzle
The combined slotted adapter is designed for vacuuming areas with difficult access, such as radiators, slots, corners,
pedestals, spaces between upholstery, and so on.
2. Nozzle with a brush for upholstery
This nozzle is used to clean smaller upholstered surfaces. The brush is designed for vacuuming and cleaning shelves,
books, furniture etc.
3. Turbo brush
Designed for deeper vacuuming of carpets. It achieves much better results than the classic floor attachment.

USING THE VACUUM CLEANER

NOTE
Prior to using the vacuum cleaner, please make sure that the filters and the dust bag have been placed and installed
properly. Unwind the necessary length of the power cord. The ideal length of the power cord is marked by a yellow dot
on the cord. Do not unwind the power cord past the red mark!
1. Adjust the power controller to the minimum setting.
2. Insert the plug into the mains outlet.
3. Press the main switch on the vacuum cleaner.
4. Set the required suction power using the controller.
VP9231
Fig. 1
Fig. 2
39