Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
LEGEND
The product satisfies the relevant safety
standards.
Read instructions before use.
The product must be recycled.
WARNING! or CAUTION! or REMEMBER!
Applicable to the given situation (general
warning sign).
ATTENTION! Electric shock warning!
ATTENTION! Hot surface, risk of burns!
Only use indoors.
ATTENTION! Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury or even death.
The terms „device" or „product" are used in the warnings
and instructions to refer to CREPE MAKER; DOUBLE
CREPE MAKER.
ELECTRICAL SAFETY
a)
The plug must fit the socket. Do not modify the plug
in any way. Using original plugs and matching sockets
reduces the risk of electric shock.
b)
Avoid touching earthed elements such as pipes,
heaters, boilers and refrigerators. There is an increased
risk of electric shock if the earthed device is exposed
to rain, comes into direct contact with a wet surface
or is operating in a damp environment. Water getting
into the device increases the risk of damage to the
device and of electric shock.
c)
Do not touch the device with wet or damp hands.
d)
Use the cable only for its designated use. Never use it
to carry the device or to pull the plug out of a socket.
Keep the cable away from heat sources, oil, sharp
edges or moving parts. Damaged or tangled cables
increase the risk of electric shock.
e)
If using the device in a damp environment cannot be
avoided, a residual current device (RCD) should be
applied. The use of an RCD reduces the risk of electric
shock.
f)
Do not use the device if the power cord is damaged
or shows obvious signs of wear. A damaged power
cord should be replaced by a qualified electrician or
the manufacturer's service centre.
g)
To avoid electric shock, do not immerse the cord, plug
or device in water or other liquids. Do not use the
device on wet surfaces.
h)
ATTENTION! DANGER TO LIFE! While cleaning, never
immerse the device in water or other liquids.
i)
Do not use in very humid environments or in the
direct vicinity of water tanks.
j)
Prevent the device from getting wet. Risk of electric
shock!
SAFETY IN THE WORKPLACE
a)
Make sure the workplace is clean and well lit. A messy
or poorly lit workplace may lead to accidents. Try
to think ahead, observe what is going on and use
common sense when working with the device.
6
U S E R M A N U A L
b)
If you discover damage or irregular operation,
immediately switch the device off and report it to a
supervisor without delay.
c)
If there are any doubts as to the correct operation
of the device, contact the manufacturer's support
service.
d)
Only the manufacturer's service point may repair the
device. Do not attempt any repairs independently!
e)
In case of fire, use a powder or carbon dioxide
(CO
) fire extinguisher (one intended for use on live
2
electrical devices) to put it out.
f)
Children or unauthorised persons are forbidden to
enter a work station. (A distraction may result in loss
of control over the device).
g)
Use the device in a well-ventilated space.
h)
Please keep this manual available for future reference.
If this device is passed on to a third party, the manual
must be passed on with it.
i)
Keep packaging elements and small assembly parts in
a place not available to children.
j)
Keep the device away from children and animals.
REMEMBER! When using the device, protect children
and other bystanders.
PERSONAL SAFETY
a)
Do not use the device when tired, ill or under the
influence of alcohol, narcotics or medication which
can significantly impair the ability to operate the
device.
b)
The device is not designed to be handled by persons
(including children) with limited mental and sensory
functions or persons lacking relevant experience and/
or knowledge unless they are supervised by a person
responsible for their safety or they have received
instruction on how to operate the device.
c)
When working with the device, use common sense
and stay alert. Temporary loss of concentration while
using the device may lead to serious injuries.
d)
Do not overestimate your abilities. When using the
device, keep your balance and remain stable at all
times. This will ensure better control over the device
in unexpected situations.
e)
The device is not a toy. Children must be supervised
to ensure that they do not play with the device.
f)
To prevent the device from accidentally switching
on, make sure that the thermostat knob is in the 0
position before connecting to a power source.
SAFE DEVICE USE
a)
Do not use the device if the thermostat knob does not
function properly. Devices which cannot be switched
on and off using the switch are hazardous, should not
be operated and must be repaired.
b)
Disconnect the device from the power supply
before commencement of adjustment, cleaning and
maintenance. Such a preventive measure reduces the
risk of accidental activation.
c)
When not in use, store in a safe place, away from
children and people not familiar with the device who
have not read the user manual. The device may pose
a hazard in the hands of inexperienced users.
Rev. 13.07.2021
d)
Keep the device in perfect technical condition. Before
each use check for general damage and especially
check for cracked parts or elements and for any other
conditions which may impact the safe operation of
the device. If damage is discovered, hand over the
device for repair before use.
e)
Keep the device out of the reach of children.
f)
Device repair or maintenance should be carried out
by qualified persons, only using original spare parts.
This will ensure safe use.
g)
To ensure the operational integrity of the device, do
not remove factory-fitted guards and do not loosen
any screws.
h)
When transporting and handling the device between
the warehouse and the destination, observe the
occupational health and safety principles for manual
transport operations which apply in the country
where the device will be used.
i)
Do not move, adjust or rotate the device in the course
of work.
j)
Do not leave this appliance unattended while it is in
use.
k)
Clean the device regularly to prevent stubborn grime
from accumulating.
l)
The device is not a toy. Cleaning and maintenance may
not be carried out by children without supervision by
an adult person.
m)
It is forbidden to interfere with the structure of
the device in order to change its parameters or
construction.
n)
Keep the device away from sources of fire and heat.
o)
Do not cover the ventilation openings!
p)
The crepe maker is getting very hot, when the device
heats up. Danger of burnings!
q)
Use only tools of heat resistant plastic or wood, to
avoid damages of the antisticking coating of the
crepe maker. Make sure the tools have sharp edges.
r)
Do not use this device for drying or heating objects.
s)
Use kitchen utensils that are intended for use with
food and that will not scratch the appliance. Do not
use sharp and metal objects.
t)
Regularly clean the tray to prevent permanent dirt
deposits.
u)
During operation, the appliance reaches high
temperatures. Do not place the appliance near
flammable or easily melting surfaces or near
flammable materials.
ATTENTION! Despite the safe design of the device
and its protective features, and despite the use of
additional elements protecting the operator, there is
still a slight risk of accident or injury when using the
device. Stay alert and use common sense when using
the device.
Rev. 13.07.2021
EN
7
Werbung
Inhaltsverzeichnis
