BRAYER BR1106 Bedienungsanleitung Seite 7

and pour the water out of the cup.
• Depending on the cup capacity repeat this procedure
several times until the boiler is clean.
ATTENTION!
• Do not remove the filter holder (5) when the
buttons (9,10) are pressed.
• Do not remove the filter holder (5) immediately
after preparing coffee as there is redundant water
and steam pressure inside the filter (5), let the
coffee maker cool down completely.
• To remove the filter holder (5) turn the handle (3)
to the left « » and remove the filter holder (5).
AUTO SWITCH OFF FUNCTION
• If no actions were performed during 29 minutes
after switching on, the coffee maker will switch off
automatically.
HOW TO MAKE A GOOD ESPRESSO
• Use ground coffee for espresso coffee makers.
• Slightly tamp the ground coffee in the filter (6), you
can do it with the back side of the measuring spoon
(20).
• Coffee strength depends on the quality and grinding
degree of coffee beans. If coffee is pouring out too
long, this means the coffee powder is too fine or it is
tamped too strongly.
THERMOMETER
You can control the temperature by the indicators
(10, 12) and with the built-in thermometer (7). The
thermometer (7) scale shows the water temperature in
the coffee maker.
PREHEATING
• To make a cup of hot espresso, it is recommended to
preliminary heat up the coffee filter (6) and the filter
holder (5).
• Remove the tank (15), оpen the lid (13) and fill the
tank (15) with water, or remove the tank (15) and fill it
with water, then install the tank (15) back to its place.
• Install the coffee filter (6) into the holder (5) having
preliminary matched the ledge on the filter (6) with
the groove on the holder (5) and turn the filter (6)
counter/clockwise to fix the filter.
• Install the filter holder (5) into the coffee maker. The
holder (5) ledges should match the grooves on the
boiler « », after that turn the filter holder handle
(3) to the right until bumping «
• Place a suitable cup on the grid (2).
• Insert the power plug into the mains socket.
• Switch the coffee maker on, setting the power switch
(19) to the «I» position, the indicator (11) will light up,
and the ready indicator (10) will start flashing.
• Wait until the indicator (10) «
switch the water supply on by pressing the button
EN 7
».
» lights up, then