BRAYER BR1106 Bedienungsanleitung Seite 10

10 EN
6%, cream fat status is not less than 10%.
- Clean the tip (18) right after making frothed milk -
to do that put the tip (17,18) into a glass with water
and switch the steam supply on by pressing the
button (8) « », turn the steam supply knob (16)
« / » counterclockwise to release some steam.
After that close the steam supply by turning the
knob (16) « / » to the position « ». Switch the
steam supply off by pressing the steam supply
button (8) « » and switch the coffee maker off.
- Wait until the coffee maker cools down and
remove the tip (18) from the cappuccinator pipe
(17), wipe the outer side of the cappuccinator pipe
(17) with a soft damp cloth and wash the tip (18)
under a water jet.
Note:
- after making frothed milk, if you press the water
supply button (9) «
be flashing quickly and the water supply will not
switch on, because the water temperature in the
boiler is high. To decrease the water temperature,
put a cup under the tip (18), turn the knob (16) «
/ » to the position « » and drain hot water.
When the indicator (10) glows constantly, turn the
knob (16) « / » to the position « », and you
can resume making coffee.
», the indicator (10) will
WARMING THE DRINKS
You can warm up your drinks by putting the
cappuccinator pipe (17) without the tip (18) into the cup
with the drink.
• Press the steam supply button (8) «
the indicator (12) lights up.
• Put the cappuccinator pipe (17) without the tip (18)
into the cup with the drink you want to warm up.
Carefully turn the steam supply control knob (16)
« / » to the position « ».
• Close the steam supply by turning the knob (16)
« / » to the position « ».
• Switch the steam supply off by pressing the steam
supply button (8) « » again.
• Switch the coffee maker off by pressing the on/off
button (19) « », the indicator (11) will go out.
Note: some water or steam may appear from the filter
holder (5), it is normal.
REMOVING MINERAL SCALE
After 500 cycles of making coffee and frothing milk the
descaling notification will switch on and the indicators
(10, 12) will be flashing simultaneously.
1. Make sure that the control buttons (8, 9) are in the
off position.
2. Make sure that the steam supply is closed. To do
this turn the knob (16) «
», wait until
/ » to the position « ».