IFM Electronic ecomat 200 FS-1 Betriebsanleitung Seite 30

FS-1 / FS-1N
MONITOR
NCx Number of Cams (on inputs 1/2)
Number of cams detected per revolution. On the basis of this value the monitor calculates
the rotational speed (measured frequency ÷ NCx = displayed speed in RPM).
For frequency measurements NCx = 1 should remain set.
• Values: 1...999
• Default value: 1
EF1 Enable Frequency (slip monitoring becomes active above EF1)
This function is used as time-independent start-up delay (cf. STx)
To be used in applications where at start up the synchronicity between master and slave is
expected to be higher than normal (e.g. grinding gear).
Output 1 (slip monitoring) is maintained in the "good" state until the drive has reached
the set value EF1.
• Values: 0.1...1000.0 Hz or 1...60,000 RPM (Note parameter DIM!)
• Default value: 1 (RPM)
MF1 Multiplication Factor (multiplier)
By means of the parameters MF1 and DF1 the transmission ratio or the gear reduction
ratio is calculated. They enable a conversion of the power take-off side to the rotational
speed level of the drive.
• Values: 1...10,000 (whole numbers)
• Default value: 1
Example transmission by means of V-belt:
power take-off
1800 RPM
DF1 = 1800
Example gear reduction
power take-off
800 RPM
DF1 = 800
DF1 Division Factor (divisor)
see MF1
• Values: 1...10,000 (only whole numbers)
• Default value: 1
DIM Dimension (display format)
Indication in Hz or RPM (revolutions per minute)
When a new unit is selected the monitor converts all existing values into the new unit!
• Values: 0 = RPM / 1 = Hz
• Default value: 0 (RPM)
VER Software Version
Possibility to check which software version is installed
(5-digit number with the abbreviation VCO)
30
PAGE
All manuals and user guides at all-guides.com
drive
1500 RPM
MF1 = 1500
drive
1000 RPM
MF1 = 1000
Rotational speed power take-off x
power take-off Abtrieb
power take-off
Abtrieb
MF1
= rotational speed drive
DF1
Antrieb drive
drive
Antrieb