Starting The Programme; Changing Programme; Programme Complete / Laundry Unloading - AEG LAVATHERM 59850 Benutzerinformation

The padlock symbol
activated.
The child safety device is not deactivated once the programme comes to an end.
If you want to set a new programme, you must first deactivate the child safety device.

Starting the programme

Press the START PAUSE (START PAUZE) button (6). The programme is started.
The programme progress is shown in LCD by appropriate set of icons. From left to the
right, from iron dry
in case of cupboard dry programme the following status icons are visible:
. Current cycle progress is marked by flashing dash under status icon. When appropri-
ate part of drying cycle is accomplished dash becomes steady and appears flashing under
next status icon.

Changing programme

To change a programme which has been selected by mistake once the programme has
started, first turn the programme selector to OFF and then reset the programme.
The programme can no longer be changed directly once the programme has started. If
nevertheless there is an attempt to change the programme on the programme knob, the
programme progress display and the maintenance indicators flash. If an option (exclud-
ing the buzzer ) is set, Err appears in the multidisplay. The drying programme is not how-
ever affected by this (laundry protection).

Programme complete / Laundry unloading

Once the drying cycle is complete, display shows a blinking
appears dash. If the buzzer option has been set, an acoustic signal sounds intermittently
for about one minute.
The drying cycles (except for the WOOL programme) are automatically followed by an anti-
crease phase which lasts around 30 minutes. The drum rotates at intervals during this
phase. This keeps the laundry loose and free of creases. The laundry can be removed at
any time during the anti-crease phase. (The laundry should be taken out towards the end
of the anti-crease phase at the latest to prevent creases from forming.) If long anti-
crease
option has been set, the anti-crease phase is lengthened by 60 minutes.
1. Open door.
2. Before removing the laundry, remove fluff from the micro-fine filter. It is best to use
a damp hand for this purpose. (See "Care and cleaning" chapter.)
3. Remove laundry.
4. Turn the programme selector to OFF (UIT) .
After each drying cycle:
- Clean the micro-fine filter and fine filter
- Drain the condensed water container
(See chapter "Care and cleaning".)
5. Close the door.
appears in the display to indicate that the child safety device is
to anti-crease
icon depends on the drying cycle chosen. E. g.
Daily use
, under anti-crease
93
icon