End Of The Programme; Fluff In The Fabrics - AEG LB 3470 WT Benutzerinformation

22 www.aeg.com
2. Load the laundry one item at a time.
To have a good drying
performance do not exceed
the maximum drying loads
recommended in the user
manual. Do not set a spin
speed lower than the
automatic speed of the set
programme.
3. Put the detergent and the additives
in the appropriate compartment.
4. Turn the programme dial to the
washing programme.
The display shows the indicators of the
different washing phases.
5. Set the available options.
12.2 Washing & Automatic
drying
1. Press Drying level again and again
until the display shows one of the
dryness level indicator:
•
cotton items
•
indicator for cotton and synthetic
items
•
for cotton items
The display shows the indicator
time value on the display is the duration
of the washing + drying cycles,
calculated on a default load size.
To have a good drying the
appliance does not let you
set a too low spin speed for
the items to be washed and
dried.
2. Press Start/Pause to start the
programme.
In the display the indicator of the set
dryness level stays on.
The door locked indicator
The display shows regularly a new time
value.
The last minutes of the
drying cycle the appliance
performs the anti-crease and
the cooling phases.
: IRON DRY level indicator for
: CUPBOARD DRY level
: EXTRA DRY level indicator
12.3 Washing & Timed Drying
To have a good drying the appliance
does not let you set a too low spin speed
for the items to be washed and dried.
1. Press Drying time to set the drying
time value. The display shows 10
minutes.
The indicator
The display shows the set drying value
time. for example:
seconds the display shows the final time
value
the washing and drying cycles (washing +
drying + anti-crease + cooling phases).
2. Press Start/Pause to start the
programme.
In the display the indicator
on. The door is locked. The display
shows regularly a new time value.

12.4 End of the programme

The appliance stops automatically. The
acoustic signals operate (if they are
active).
For more information see 'At the end of
. The
the drying programme " of the previous
chapter.
1. Remove the laundry from the
appliance.
Make sure that the drum is empty.
2. Keep the door ajar, to prevent
mildew and odours.

12.5 Fluff in the fabrics

During the washing and/or drying phase,
some types of fabric, (sponge, wool,
sweatshirt) could release fluff.
The released fluff could stick to the
goes on.
fabrics during the next cycle.
This inconvenient increases with
technical fabrics.
To prevent the fluff in your laundry, we
recommend that you:
comes on in the display.
. After some
, that is the total duration of
If you set only 10 minutes of
drying after washing, the
appliance calculates also the
duration of the anti-crease
and the cooling phases.
comes