Installation - Gewiss Сhorus GW 10 784 Installationsanleitung

The actuator is configured with the ETS software to create the functions listed below.
Switchover:
- parameterisation of output behaviour (NO/NC)
- timing of stair raiser lights, with the possibility to set the duration of the timing via BUS
- timing of the stair raiser lights, with switch-off pre-warning function
- activation/deactivation delay
- flashing
The functions can be used simultaneously with special, autonomous communication elements.
Scenes:
- storage and activation of 8 scenes (value 0-63) for each output
- enabling/disabling of scene storage from BUS
Priority commands:
- parameterisation of the output relay value at the end of the forcing
Shutdown command:
- parameterisation of the shutdown item value and output relay value at the end of the forcing
Safety functions:
- regular monitoring of the input item
Logic functions:
- AND/NAND/OR/NOR logic operation with command element (switchover, timed switchover,
delayed switchover, flashing) and the result of the logic operation
- use of the logic operation result to enable the command element (switchover, timed switchover,
delayed switchover, flashing, scene)
- AND/NAND/OR/NOR/XOR/XNOR logic operations up to 4 logic inputs
Output status:
- the sending on the BUS can be parameterised
Other functions:
- parameterisation of output behaviour upon failure and resetting of voltage supply on BUS
- parameterisation of behaviour of local command push-buttons

INSTALLATION

Functions - actuator section
14