Presentation; Delivery Condition; Introduction - Chauvin Arnoux CA 6651 Bedienungsanleitung

1.1. DELIVERY CONDITION

The CA 6651 is delivered in a cardboard box containing:
„ One carrying case
„ One cable terminated by a type 2 connector
„ Operating instructions in 5 languages
For the accessories and spares, consult our web site:
www.chauvin-arnoux.com

1.2. INTRODUCTION

Charging stations for electric cars must be tested after installation, then tested periodically when in service.
The CA 6651 is used to:
„ Check the connections of the protective conductor (charging terminal side and vehicle side).
„ Simulate the connection of an electric vehicle to the charging station being tested.
Different charging levels can be simulated (NC, 13A, 20A, 32A and 63A) along with different electric
vehicle charging modes (A, B, C, D).
„ Access the different points of the type 2 connector (L1, L2, L3, N, PE) and use them to perform tests.
With a multifunction tester connected to the CA 6651, you can:
„ Make earth measurements,
„ Perform RCD (differential) tests,
„ Make insulation measurements,
„ Make continuity measurements.
With an oscilloscope connected to the CA 6651, you can also observe the pilot signal.
The CA 6651 is powered by the charging station it is testing.
The CA 6651 is intended for use in charging mode 3 with a type 2 connector. This means that the charging
is controlled by the terminal.
The CA 6651 does not allow the charging of electric vehicles.
The operation of the CA 6651 satisfies the requirements of the following standards:
„ IEC 61851-1: Electric vehicle conductive charging system - Part 1: General requirements,
„ IEC 60364-7-722: Requirements for special installations or locations - Supplies for electric vehicles.

1. PRESENTATION

20