Technoline WS1900 Bedienungsanleitung Seite 53

To set alert
1 . Press [ ALERT ] to select and display the desired weather alert reading in the sequence
below:
Alert reading Sequence
Indoor Temperature High Alert
(current channel)
Indoor Temperature Low Alert
(current channel)
Indoor Humidity High Alert
(current channel)
Indoor Humidity Low Alert
(current channel)
Outdoor Temperature High Alert
Outdoor Temperature Low Alert
Outdoor Humidity High Alert
Outdoor Humidity Low Alert
Average Wind Speed
Pressure Drop
Hourly Rainfall
2 . Under the current alert reading, press and hold [ ALERT ] key for 2 seconds to enter alert
setting and the alert reading will flash.
3 . Press [ Ʌ ] or [ V ] key to adjust the value or press and hold the key to change rapidly.
4 . Press [ ALERT ] key to confirm the value.
5 . Press [ ALARM ] key to toggle the regarding alert on / off.
6 . Press [ ALERT ] key to step to next alert reading.
High /Low
Alert on
7 . Press any key on the front side to save alert on /off status and back to normal mode, or it
will automatically back to normal mode after 30 seconds without pressing any key.
To stop the active alert
Press [ SNOOZE ] key to silence the alert alarm or let the alarm automatically turn off after 2
minutes.
Note:

Once the alert is triggered, the alarm will sound for 2 minutes and the related alert icon
and readings will flash.

If the alert alarm is automatically off after 2 minutes, the alert icon and readings will still
keep flash until the weather reading is out of the alert range.

The weather alert will sound again when the weather readings falls into the alert range again.
Setting Range
-40°C ~ 80°C
1% ~ 99%
-40°C ~ 80°C
1% ~ 99%
0.1m/s ~ 50m/s
1hPa ~ 10hPa
1mm ~ 1000mm
Alert on
Display Section
Indoor / CH
temperature & humidity
Outdoor temperature &
humidity
Wind direction & speed
Barometer
Rainfall
Alert off
EN 21
Default Value
40°C
0°C
80%
40%
40°C
0°C
80%
40%
17.2mm/h
3hPa
100mm
Alert off