WIKA CPH7650 Betriebsanleitung Seite 28

6. Commissioning, operation
Operating mode: CALIBRATION
In the CALIBRATION mode the data shown above the dashed dividing line is the same
as in the "MEASURING with test item" mode.
EN
a
b
c
d
e
f
g
Pressure signal (test item)
a) Current measured value of the CPT6000 reference pressure sensor
b) Current measured value of the test item
c) Deviation between the test item and reference
d) Set point of the calibration
e) Actual value of the calibration
f) P - 01: Test item No. 1
<01>: Test step No. 1
g) IDENT number of the test item
h) Current value of the output signal of the test item
28
All manuals and user guides at all-guides.com
P I/U
switchable
Electrical signal (test item)
WIKA operating instructions, model CPH7650
h