GF CNC 4.0 400 Betriebsanleitung Seite 36

8 WELDING
Warning
Advice
Advice
Attention
30
The calculated drag pressure is shown at lower right side of the display.
To repeat the measurement of the drag pressure press button ◄ .
Danger of cutting hands!
Sharp planer blades!
Danger of injury to hands if the planer disk is touched.
Do not touch the rotating planer disk.
Clean the blades before first use of planer!
The blades are protected by an anticorrosive treatment. The blades must
be cleaned with lint-free paper and cleaner like trichloroethylene or pure
industrial alcohol (such as "Tangit KS").
To get a correct alignment and, in consequence, a correct planing of the
pipes, use roller supports (at least 1 roller support per pipe)!
Insert the planer to the base machine with care and snap in the safety
lock machanism. This prevents the planer unit from tilting out of the
machine during the planing process.
CNC 4.0 400
Check if the planer motor switch is set ON, then start the process by
pushing the button
If the planer does not start, check that the signal lamp is ON, indicating
that the planer is inserted correctly.
CNC 4.0 500 - 630
Switch on the planer motor by pressing the black toggle switch, near
the "Emergency Stop" button. The planer discs are starting to turn.
Now you can confirm that the motor has been actually activated by
pushing the button OK : the display moves to the next page.
Operating instructions CNC 4.0 400/500/630
: the display moves to the next page.