Yuma - Specification; Tightening Torque; Suspension - PROPAIN YUMA Bedienungsanleitung & Aufbauanleitung

11
Yuma – specification
PROPAIN's Yuma is a Enduro Bike. Please find the according cat-
egory in the "user handbook bicycles" which is included in your bike
delivery. Be sure to use your bicycle only according to the "intended
use" specified by the category.
If you replace parts of your bicycle, please pay special attention to
the hardware compatibility. If in doubt, please contact Propain or
your local bike dealer.
The Yuma has the following specifications:
Maximum front travel allowed:
Rear travel:
Shock length:
Shock travel:
Shock mount top:
Shock mount bottom:
Bottom bracket:
Break mount:
Seat post diameter:
150mm
145mm
185mm
55mm
Trunnion Mount
8mm x 25mm
73mm BSA
Post Mount 160
31,6mm
Headset:
Rear wheel axle:
Chain line:
Chain guide mount:
Recommended tire size:

Tightening torque

The mounting bolts of the frame and suspension have to be tight-
ened according to the table below. After untightening any bolts
Propain recommends using Loctite 243 (medium) before tightening
the bolts again. Please also consider the drying time of Loctite.

Suspension

Bearing
1)
2)
3)
Tapered – Top: IS42 /
Bottom: IS52
148mm (Boost)
52mm
ISCG05
24"/26"
Tightening torque
25 Nm / 18,44 ft lb
18 Nm / 13,30 ft lb
15 Nm / 11.1 ft lb