Spindrift - Specification; Tightening Torque; Suspension - PROPAIN SPINDRIFT Bedienungsanleitung

11
Spindrift – specification
PROPAIN's Spindrift is a Freeride Bike. Please find the according
category in the "user handbook bicycles" which is included in your
bike delivery. Be sure to use your bicycle only according to the "in-
tended use" specified by the category.
If you replace parts of your bicycle, please pay special attention to
the hardware compatibility. If in doubt, please contact Propain or
your local bike dealer.
The Spindrift has the following specifications:
Maximum front travel allowed:
Rear travel:
Shock length:
Shock travel:
Shock mount top and bottom:
Bottom bracket:
Break mount:
Seat post diameter:
Headset (S.H.I.S.):
Downloaded from www.Manualslib.com
180mm
180mm
230mm
60mm
8mm x 20mm
73mm BSA
Post Mount 180
31,6mm
Tapered – Top: IS42 /
Bottom: IS52
manuals search engine
Rear wheel axle:
Chain line:
Chain guide mount:
Recommended tire size:

Tightening torque

The mounting bolts of the frame and suspension have to be tight-
ened according to the table below. After untightening any bolts
Propain recommends using Loctite 243 (medium) before tightening
the bolts again. Please also consider the drying time of Loctite.

Suspension

Bearing
1)
2)
3)
4)
148mm Syntace X12
52mm (Boost)
ISCG05
650B (27,5")
Tightening torque
25 Nm / 18,44 ft lb
25 Nm / 18,44 ft lb
9 Nm / 6,64 ft lb
25 Nm / 18,44 ft lb