Last Function Memory; Initialization Of The Microprocessor - Denon ADV-1000 Bedienungsanleitung

ENGLISH
POWER
(6) "OTHER SETUP" is selected
VCR POWER
TV
TV POWER TV POWER CH TV/VCR SLEEP
CALL +10 0
DISPLAY RETURN INPUT MODE SURROUND
MENU
FUNCTION
2,3,4
ENTER
2,3,4
MODE
VOLUME
BAND
MUTE
CH SHIFT
NTSC/PAL STATUS
TU MEMO
SUB TITLE AUDIO ANGLE TOP MENU
RDS PTY CT RT
PROG/DIRECT REPEAT A-B REPEAT RANDOM
CH.SELECT T.TONE SDB/TONE SURR.PARA
SETUP CDR/MD/TAPE TUNER/TV/VCR DVD
1
REMOCON MODE
1
See page 41.
2
3
Use the and cursor buttons to select the
desired setting, then press the ENTER button.
• CAPTIONS
Use this to set whether or not to display the
closed captions recorded on DVDs.
To exit the other setup mode
Use the and cursor buttons to select
"DVD SETUP MENU", then press the ENTER
button.
• The screen returns to as it was in step 2.
4
Use the and cursor buttons to select the
desired setting, then press the ENTER button.
2 When "CAPTIONS" is selected:
• OFF (Factory default)
Select this when you do not want to display the
captions on the screen when playing DVDs
containing English captions.
• ON
Select this to display the captions on the screen
when playing DVDs containing English captions.
To exit the captions mode
Press the ENTER button, you can go back to the
previous screen.
• The screen returns to as it was in step 2.
46
NOTES:
• An English caption decoder is required to display English
captions.
• DVDs with caption signals are indicated by the
, , mark.
English captions cannot be displayed when playing DVDs
which do not contain caption signals.
• The characters in which the captions are displayed
(capital letters, small letters, italics, etc.) depend on the
DVD and cannot be selected with this unit.
OTHER SE TUP B
CAPT I ONS ONS OF F
> DVD SETUP MENU DVD SETUP MENU
Remote control unit
d
ENTER
SELECT : DEC I S ION: ENTER BUTTON
Remote control unit
CAP T I ONS B
CAPT I ONS OFF
ON
Remote control unit
d
ENTER
SELECT : DEC I S ION: ENTER BUTTON
Remote control unit
21

LAST FUNCTION MEMORY

• This unit is equipped with a last function memory which stores the input and output setting conditions as they were immediately
before the power is switched off.
This function eliminates the need to perform complicated resettings when the power is switched on.
• The unit is also equipped with a back-up memory. This function provides memory storage when the power switch is off and with
,
the power cord disconnected.
22

INITIALIZATION OF THE MICROPROCESSOR

When the indication of the display is not normal or when the operation of the unit does not shows the reasonable result, the
initialization of the microprocessor is required by the following procedure.
1
Press the power button to set the
standby mode, then unplug the
set's power cord from the wall
power outlet.
2
Hold the following PLAY ( ) button and STOP (
1
button, and plug the AC cord into the outlet.
3
Check that the entire display is flashing with an interval
of about 1 second, and release your fingers from the 2
buttons and the microprocessor will be initialized.
ON / STANDBY
Green
1 2 2
)
2
NOTES:
• If step 3 does not work, start over from step 1.
• If the microprocessor is reset, all the buttons and the
setup settings are reset to the factory default values.