Automatic Switching - LEGRAND C2G C2G30022 Bedienungsanleitung

Dual HDMI HDBaseT + RS232 over Cat Extender Single Gang Wall Plate Transmitter - 4K 60Hz

Automatic Switching

The transmitter offers automatic switching function.
1. The priority is HDMI IN 1 > HDMI IN 2.
Note: When power on the transmitter (no other switching operation), the default selected input source is as follows:
2. The automatic switching function follows the Last-In-First-Out rule. For example, if a new active source is connected, the
transmitter will automatically switch to this source.
3. When removing the selected source, if another HDMI port has an active source, the transmitter will automatically switch to this
HDMI source. If another HDMI port has no active source, the transmitter will keep the current selection.
Note:
The automatic switching function can detect the input signal with 5V only. If the selected source in standby mode provides a
•
continuous 5V power output, this function will not work, i.e. the transmitter will not switch the input to other active sources. In
this case, please turn off the selected source in standby mode or remove it from the transmitter.
Users can switch input source manually through front panel button or API commands.
•
4
(us)
(us)